I am in need for someone to supply and install 2 external wooden doors. They must be experienced in this. one door opens outward and will need a strip down the length of the door that covers the opening to prevent the door from being forced open from the outside. Door frame size is cm x 81cm Other door opens inward to the loft room and is shorter than standard. frame size cm x 81cm Both doors have good hinges but need decent handles and secure outdoor locks. Good quality wooden external door but not decorative
It is currently a roller door(old and worn), and the gap above the door does not allow for a folding door. So I need a replacement roller door, powder-coated white. Quote with and without a motor, as we already have a Digidoor motor for the current door. If the motor won't work with your, please state so, thanks (it is a standard width and height single garage door opening)
Need a double door opening to outside. Currently there is a wood and glass door and frame in the position, would like it replaces with aluminium and glass doors and frame. Measurement from where concrete wall meets wooden frame is cm high cm wide. See attached photo. I prefer being contacted via email or Whatsapp
I have security gates at my home in Pretoria that are very secure. They are heavy steel gates with three levers - one at the top, the middle and the bottom of the gate. I am planning on building a new home in Ballito soon and want to install the same kind of gates. I am looking to have this done sometime in May.
Main bed; 1x 2,4x2,1 sliding (with 1x 0,6x 1,4 2x top hung side wind), 2x Bedrms; 2x 1,8x 1,8 (with 2x top hung to side half each. remainder fixed) Lounge/dining; Stoep sliding 1x2,5x2,1 (no side panel) 1x 1,8x1,8 (with 2x top hung side openers) 1x 0,9x0,65 (top hung opener) Kitchen; 1x 1,5x0,9 (middle fixed 2x side top hung openers) Flat; 1x 2,1x 2,1 Sliding with side light 1x 0,6x1,5 with 2x t/h openers) Kitchenette; 1x1,8x0,9 with (2x t/h openers to sides) Room; 1x1,8x1,5 with (2x t/h openers) Bath; 1x0,9x0,9 (with 2x t/h openers) 3x toilets; 3x 0,5x0,9 (t/h openers)
1 Standard Double Sectional Automated lift door with draughtproofing. The existing Double is of the 40 raised panel type single up and over and will remain in place until all new brickwork is completed 3 mtrs forward of existing door and new door to be fitted before removal of the old door. This is for security reasons. This installation/removal is subject to planning approval and completion of new brickwork and roofing not earlier than September/October time.
I have a degrees sea view on my patio and I do not want to block the ocean views at all. I would therefore like folding windows in the front of the patio and sliding windows on the side. I am not sure exactly how many windows I will need as I am not sure about the sizes of the windows - I would need someone to advise me on that.
Good day. Can I kindly request a quote. I want to close my patio with either sliding doors or stackable doors depending on affordability. Main door = 6m wide X 2.5m high. Second opening = 1.7m wide X 2.5m high Third opening = 1.5m wide X 2.5m There are two existing sliding doors which I'd like to remove and reuse if possible, their measurements are as follows; 2.4m wide X 2.1m high 1.8m wide X 2.1m high I understand that the final quote will be based on final measurements but I'm seeking an estimate for now. Please quote me and advise with regards to alternative options as I am not fixed with heights. If the 2.1m heights are more feasible, then I'll be happy to install block windows above the doors. The two sides of the patio do not need to be accessible.
The measurements (4 options) I need for the sliding doors are: 3m (L) x 4.5m (w) left and 4.5m (w) 2.8m (L) x 4.5m (w) left x 4.5m (w) right 3m (L) x 4m (w) left x 4m (w) right 2.8m (L) x 4m (w) left x 4m (w)right Please note that the sliding doors will have a pocket in the wall where they stack into when opened. The floor track preferably recessed. The measurements are for doors that meet at a corner 90 degree opening. They can stack separately on either side.
I've got a single door garage door which the installer bought from Doorman Vredenburg. The top part was not stable from beginning, the installer told me it was a factory fault and he will replace it for me. To make a long story short, he disappeared along with the Doorman agent in Vredenburg. I need a quote for the top part and somebody to replace it for me.