I have old metal gates that my late dad put in years ago. I had palisades put in to heighten the walls, to make the property more secure. Now I need the gates heightened by joining them to a metal base that must be made. I will accept advice on best method and materials to use. I also want to convert these gates from swing gates to folding sliding gates placed onto a metal rail. I attach a rough schematic. I attach pictures taken of the palisade installation. It can be see that the gates need a base to be made to heighten per schematic attached. Please advise.
Please see attached pics, we are wanting to also pop rivet a sheet of rubber against the gate as this gate is in the middle of our son's cricket net, we are busy building and worried about the noise and damage. I need the gate installed, a new gate and if you could do the sheeting then it's a bonus but we can also purchase this and install it ourselves, just want to make sure what ever is quoted that it is possible to do.
I have a wooden garage door and it has a motor but currently it is removed and we are lifting the door by hand and it is very heavy and dangerous. The wheels along the side are also not in good condition. I was hoping for someone to come see it in person for free and we will gladly pay for it to get fixed.
It is currently a roller door(old and worn), and the gap above the door does not allow for a folding door. So I need a replacement roller door, powder-coated white. Quote with and without a motor, as we already have a Digidoor motor for the current door. If the motor won't work with your, please state so, thanks (it is a standard width and height single garage door opening)
There is a hole in the bottom timber section of double garage door. My husband has taken a look and the wood does not seem to be rotten. We need someone to offer some advice and let us know whether repairs are even possible and how much it cost. The garage door would be at my son's house in Fourways.
I have security gates at my home in Pretoria that are very secure. They are heavy steel gates with three levers - one at the top, the middle and the bottom of the gate. I am planning on building a new home in Ballito soon and want to install the same kind of gates. I am looking to have this done sometime in May.
Good day, I am looking for technicians who can repair Gate Motor or other issues with the front gate. The complex is located in Burger Street. I need service providers who can be available on-call when the gate stops working. Kindly contact me with your details and if you are available after hours and what are you charges. This will help us to contact you immediately if we need some assistance with the gate. Thank You
I would like a black metal frame gate with fibre cement panels that go vertically that are also black. Attached is an image for the gate. Note that you cannot see through the gate and that is how I would like it. The gate needs to be 3.5 meters wide and 2 metres tall. I would like the gate to come with all the security measures needed to make sure someone does not try break in.
1 Standard Double Sectional Automated lift door with draughtproofing. The existing Double is of the 40 raised panel type single up and over and will remain in place until all new brickwork is completed 3 mtrs forward of existing door and new door to be fitted before removal of the old door. This is for security reasons. This installation/removal is subject to planning approval and completion of new brickwork and roofing not earlier than September/October time.
My wooden garden gate has perished and has always been too heavy for its frame. It is in direct sunlight all day and exposed to rain so I need advice on material. I think the frame is still ok, but may need to be reinforced into the wall. The dims of the gate itself are 80cm x cm. Photos attached. I can use the existing lock but the slot would need to be cut out. I can use the existing handles. The colour is a dark brown according to estate colours. It does not need to be completely solid; it can be slotted. I can stain it providing I am given advice as to which primer and stain should be used, dependant on material of the gate. The finished item would need to be hung/lock fitted. I am not looking for a high-end product, but certainly one that would last.
