Can I put up barbed wire on my property?
Usually, the answer is no. With a few exceptions.
I am not completely sure about the height of the fence. There is a blind spot at the back of our plot that needs the fence.
1.6m high above ground level fencing with Anchor and corner posts of 2.1 m x – mm diameter Creosote standards (Class 3) bearing the SABS mark to be placed mm and 1.6 m high droppers every 4 m along with I-Beam Iron Standards of mm. Gate posts: • 2.4 m Creosote posts bearing the SABS-mark. • Minimum diameter of mm on the thin end. • Thick end of the post to be at the bottom of the hole. • All gate posts must be cast in concrete. • Straining posts at gates must be anchored with a single box anchor. Straining posts: • 2.1 m Creosote posts bearing the SABS-mark. • Minimum diameter of mm on the thin end. •Straining posts must be installed on both sides of a river or stream crossing or where there is a change in the horizontal or vertical alignment of the fence. • All straining and corner posts must be anchored with a box anchor.
Devil's fork gate with wooden pieces in between.
Pannel lenght mm mm height Max pale spacing mm(15 spacing at mm=mm Rail 50*50 angle iron Post 76mm*76mm square tube
a 14 meter steel palisade fence mm in height installed
45 post, 60 m razor wire for domestic house
I am looking to know what the price differences would be for supply only and for supply and installation. This fence is needed for a commercial property.
We have a big plot close to Sun City and we need barbed razor wire fencing around the perimeter of the plot. I am not % sure of the measurements of the fence and how long it needs to be, need advice with regards to this.