Powder coated black / green and galvanised
One razor wire diameter height (estimate 0,45m) by 9 slabs (13,5m) on east end vibracrete wall and 7 slabs (10,5m) on back vibracrete wall and another 9 slabs (13,5m) on west end vibracrete wall, totalling to 37,5m in length. Need to supply galvanised fixture brackets, onto each concrete upright post, as well.
Can you perhaps give me 2 quotes for concrete slab wall (2ha property) - 1 quote if you install and 1 quote if you only supply the material.
I already have a clearview fence installed and I am looking for a barbed razor wire fence for the top of the clearview fence. I have an approximate length but I am not percent sure if that length is correct. This is quite urgent as I am looking for the fence to be installed by the end of this month.
I need 1,8m x 25m clearview fence in Glenwood (Durban). There will be 2 vehicle gates and 1 pedestrian gate of 1,2m
I am not completely sure about the height of the fence. There is a blind spot at the back of our plot that needs the fence.
1.6m high above ground level fencing with Anchor and corner posts of 2.1 m x – mm diameter Creosote standards (Class 3) bearing the SABS mark to be placed mm and 1.6 m high droppers every 4 m along with I-Beam Iron Standards of mm. Gate posts: • 2.4 m Creosote posts bearing the SABS-mark. • Minimum diameter of mm on the thin end. • Thick end of the post to be at the bottom of the hole. • All gate posts must be cast in concrete. • Straining posts at gates must be anchored with a single box anchor. Straining posts: • 2.1 m Creosote posts bearing the SABS-mark. • Minimum diameter of mm on the thin end. •Straining posts must be installed on both sides of a river or stream crossing or where there is a change in the horizontal or vertical alignment of the fence. • All straining and corner posts must be anchored with a box anchor.